I continued working on the rocker panel on the drivers side yesterday. It’s going pretty good. I’m trying to be patient about it, so I do a very good job, rather than what I want to do, and rush to get it done, so I can slap the motor in it and drive!
I bent up the rocker panel on Jeff’s sheetmetal brake last week, and now that I have started putting it in, I realize I have one of the bends, just slightly in the wrong spot. I’ll have to make a slit, in it to take out the extra material, then weld it back up… but it’s a good learning experience.
Here are some photos of the progress:
